NET/MASTER RMS Management and Operations Guide

RMS5206
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–63
Effect. record-count records of category, record-category , are copied from the
source ruleset.
Recovery. This message is informational only; no recovery action is necessary.
RMS5203 ENTER TARGET RULESET
Cause. You failed to specify the name of the ruleset to be created on the Ruleset Copy
panel or the name of the ruleset to merge into on the Ruleset Merge panel.
Effect. The action is not performed. If you are at the Ruleset Copy panel and press F3
to copy a ruleset, the ruleset is not copied. If you are at the Ruleset Merge panel and
press F3 to merge two rulesets, the rulesets are not merged. The field in which you
should specify the ruleset is highlighted.
Recovery. Enter the name of the ruleset in the highlighted field before requesting the
action again. The ruleset must be a new ruleset if you are at the Ruleset Copy panel or
an existing ruleset if you are at the Ruleset Merge panel.
RMS5204 TARGET RULESET DOES NOT EXIST
Cause. You specified a target ruleset that does not exist on the Ruleset Merge panel
and pressed F3 to start the merging operation. You can only merge into an existing
ruleset.
Effect. The rulesets are not merged. The field in which you specify the ruleset is
highlighted.
Recovery. Change the name of the target ruleset to the name of an existing ruleset and
press F3.
RMS5205 TARGET RULESET EXISTS
Cause. You specified the name of a ruleset that already exists on the Ruleset Copy
panel and pressed F3 to start the copying operation. You can only copy to a new
ruleset.
Effect. The copying operation is not performed, and no ruleset is created.
Recovery. Change the name of the new ruleset to a name that is not used by any
existing ruleset and press F3.