NET/MASTER RMS Management and Operations Guide

RMS6030
RMS Messages
A–72 115415 NonStop NET/MASTER RMS Management and Operations Guide
function-performed can have one of the following values:
ADDED indicates that a new record was created
MODIFIED indicates that an existing record was selected and modified
If rms-record is ELEMENT, the record belongs to a ruleset that is associated with
currently executing message handlers; if rms-record is TIMER, the status of the
time-based rule is ACTIVE.
Effect. The record is not saved in the RMS database, but is immediately available to
currently executing message handlers (in the case of ELEMENT) or loaded as a timer
(in the case of TIMER).
Recovery. If you also want to save the record in the RMS database, enter I (Immediate)
in the Activation field before you save the record.
RMS6030 COMMENTS MODIFIED
Cause. You typed the C (Comment) action code next to a record on your selection list
panel (for example, next to a message action rule on a Message Action Rules
Maintenance selection list panel), and pressed ENTER to add or modify the comments
for the record in the RMS database. You added or modified the comments on the
Comments Maintenance panel and pressed F3 to file the comments.
Effect. The comments are saved in the RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS6031 STATUS MUST BE A(CTIVE), I(NACTIVE), OR P(ENDING)
Cause. You specified an invalid value in the Status field on your data entry panel. This
panel could be page 1 of the message action rule definition panels or the Time-Based
Rule Definition panel.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of ACTIVE, INACTIVE, or PENDING
before requesting the action again. You can abbreviate these values to A, I, and P
respectively, and RMS expands them to the full word for you. Deleting the invalid
value and pressing ENTER puts the default value ACTIVE in the Status field.