NET/MASTER RMS Management and Operations Guide

RMS6051
RMS Messages
A–78 115415 NonStop NET/MASTER RMS Management and Operations Guide
You cannot copy messages to a message set that is not in the RMS database. The name
of the message set to which you want to copy the messages must exist in the RMS
database.
Effect. The value is not accepted. The copying operation is not performed.
Recovery. Change the invalid name to a valid name before requesting the action again.
Valid values are the names of message sets that exist in the RMS database but that are
different from the message set from which you are copying the records. You can
display the list of message sets in the RMS database to find the correct name of the
message set you require by selecting option 5 from the Event Simulation panel.
RMS6051 record-count RECORDS COPIED
Cause. You typed the CP (Copy) action code next to one or more message sets on your
Captured Message Set Selection panel or next to one or more messages on your
Captured Message Set Edit panel, and pressed ENTER. The action requested that the
selected messages be copied to another message set. You pressed ENTER from the
inset that appeared and the messages are copied. record-count indicates how
many messages were copied.
Effect. The messages are copied to and saved under the specified message set in the
RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS6052 ENTER SAVE NAME
Cause. You pressed F6 to save the captured messages while you were in the Activity
Capture panel and pressed ENTER on the inset that appeared. However, you failed to
specify a name for the message set in which to save the messages in the MESSAGE
SET field.
Effect. No message set is created, and the captured messages are not saved to the RMS
database.
Recovery. Enter a value in the MESSAGE SET field before pressing ENTER again. The
value must not be the name of an existing message set in the RMS database.