NET/MASTER RMS Management and Operations Guide

RMS6111
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–81
Recovery. Change the invalid value to one that uses the wild-card characters correctly
before requesting the action again. The question mark (?) character represents one
character, and can be used anywhere in the value except as the first character. The
asterisk (*) character represents zero or more characters, and can only be used as the
last character in the value where this character is not the only character.
If the value is in the Process Name field on page 1 of the message action rule definition
panels, the value can be of the form \systemname.$processname; that is, the value can be
divided into two components separated by a period (.).
The wild-card characters must be used correctly in each component. You use * as the
process name to match all named and unnamed processes; you use $* as the process
name to match all named processes only.
If you omit \systemname, your system is implied. If you omit $processname, all
processes are implied (\systemname.*).
RMS6108 VALID DELIVERY OPTIONS ARE Y, N, L, OR X
Cause. You specified an invalid value in the Deliver field on page 4 of the message
action rule definition panels (Message Modification panel).
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of Y (yes), N (no), L (log), or X (exit) before
requesting the action again.
RMS6110 ENTER 'BEFORE', 'AFTER', OR 'ALWAYS'
Cause. You specified an invalid value in the Do Actions field on page 4 of the message
action rule definition panels (Message Modification panel).
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of BEFORE (execute the rule actions before
the message threshold is reached), AFTER (execute the rule actions after the message
threshold is reached), or ALWAYS (always execute the rule actions), before requesting
the action again.
RMS6111 ENTER 'BEFORE' OR 'AFTER'
Cause. You specified an invalid value in the Set Variables field on page 6 of the
message action rule definition panels (Set Ruleset Variables panel).
Effect. The value is not accepted. The action is not performed.