NET/MASTER RMS Management and Operations Guide

RMS6122
RMS Messages
A–84 115415 NonStop NET/MASTER RMS Management and Operations Guide
RMS6122 PURGE TIME MUST BE BLANK IF MESSAGE GROUP ID IS BLANK
Cause. You specified a value in one of the Purge After fields on page 5 of the message
action rule definition panels (System Action panel) but no value in the corresponding
Message Group ID field.
Effect. The value is not accepted. The action is not performed.
Recovery. Ensure that the Purge After field is blank before requesting the action again.
If you need the value, you must also specify a value in the corresponding Message
Group ID field.
RMS6123 VALID OPERATORS ARE EX, EQ, LE, LT, GE, GT, CT, LK
Cause. You specified an invalid value in one of the Opr fields on page 3 of the message
action rule definition panels (third Message Validation panel).
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of the following before requesting the action
again:
EX (exactly equal to)
EQ (generically equal to)
LE (less than or equal to)
LT (less than)
GE (greater than or equal to)
GT (greater than)
CT (contain)
LK (match with the underscore (_) wild-card character that represents one
character and the percent (%) wild-card character that represents zero or more
characters)
RMS6124 OPERATOR MUST BE BLANK IF SCAN TEXT IS BLANK
Cause. You specified a value in one of the Opr fields but no value in the corresponding
Scan Text fields on page 3 of the message action rule definition panels (third Message
Validation panel).
Effect. The value is not accepted. The action is not performed.