NET/MASTER RMS Management and Operations Guide

RMS6141
RMS Messages
A–90 115415 NonStop NET/MASTER RMS Management and Operations Guide
RMS6141 SCAN TEXT NOT REFERENCED IN SCAN OPERATOR STRING
Cause. You specified an invalid expression in the RELATIONSHIP BETWEEN
ANALYSIS CRITERIA field on page 3 of the message action rule definition panels
(third Message Validation panel). The expression did not include one or more of the
numbers that refers to specified tests under MESSAGE TEXT ANALYSIS. The action
you requested requires that the expression includes all (and only) the specified tests.
Effect. The expression is not accepted. The action is not performed. The Scan Text
fields of the omitted tests and the invalid expression are highlighted.
Recovery. Change the expression to include all the numbers referring to specified tests
before requesting the action again.
RMS6142 OPERATOR MUST BE NON-BLANK IF SCAN TEXT SPECIFIED
Cause. You specified a text string in one of the Scan Text fields but no value in the
corresponding Opr field on page 3 of the message action rule definition panels (third
Message Validation panel).
Effect. The action is not performed. The Opr field is highlighted.
Recovery. Specify the operator by which the message text is to be compared to the
specified text in the highlighted Opr field before requesting the action again. Valid
values for the Opr field are as follows:
EX (exactly equal to)
EQ (generically equal to)
LE (less than or equal to)
LT (less than)
GE (greater than or equal to)
GT (greater than)
CT (contain)
LK (match with the underscore (_) wild-card character that represents one
character and the percent (%) wild-card character that represents zero or more
characters).
If you do not need the test, delete the value in the Scan Text field before requesting the
action again.