NET/MASTER RMS Management and Operations Guide

RMS6309
RMS Messages
A–94 115415 NonStop NET/MASTER RMS Management and Operations Guide
RMS6309 TIMER ID MUST BE ENTERED
Cause. While adding a time-based rule, you left the Timer ID field blank on your
Time-Based Rule Definition panel.
Effect. The action is not performed.
Recovery. Specify the name of the time-based rule in the Timer ID field before
requesting the action again. The name can contain up to 12 characters. Valid
characters are alphanumeric characters, @, #, and $. Names of time-based rules must
be unique: that is, do not specify the name of a time-based rule that already exists in
this ruleset.
RMS6310 ACTIVATION TIME MUST BE ENTERED
Cause. You left the At field blank on the Time-Based Rule Definition panel.
Effect. The action is not performed.
Recovery. Specify a value in the At field before requesting the action again. The value
must be a time in the format hh:mm:ss, and in the range 00:00:00 through 23:59:59. The
time indicates when you want the rule actions performed.
RMS6312 FREQUENCY MUST BE IN THE FORMAT HH:MM:SS
Cause. You specified a value with an invalid format in the Every field on your
Time-Based Rule Definition panel.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to a time interval in the format hh:mm:ss before
requesting the action again. The interval must be between the value specified in the
EVCMDMIN system parameter and 24:00:00, inclusive. The value indicates the time
interval at which you want the rule actions repeated.
RMS6314 FREQUENCY MUST BE SPECIFIED IF LIMIT SPECIFIED
Cause. You specified a value in the Limit field but no value in the Every field on your
Time-Based Rule Definition panel.
Effect. The action is not performed. The Every field is highlighted.