NET/MASTER RMS Management and Operations Guide

RMS6401
RMS Messages
A–96 115415 NonStop NET/MASTER RMS Management and Operations Guide
Effect. The timer is not activated. If the Activation field setting is I, the definition of
the time-based rule is saved in the RMS database.
Recovery. Issue the command SUBMIT BMON START ZRMSTMRN to restart the
timer driver. If the problem persists, contact your Tandem support representative and
provide the following:
Version of RMS that was being used
Details of the events leading up to the display of the error
Copy of RMS database
Copy of activity log
RMS6401 COMMAND GROUP MODIFIED
Cause. You modified a command group in the RMS database through option 4
(Command Groups Maintenance) on the Rule Maintenance panel.
Effect. The modified command group record is saved in the RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS6402 COMMAND GROUP ADDED
Cause. You added a command group to the RMS database through option 4
(Command Groups Maintenance) on the Rule Maintenance panel.
Effect. A record defining the commands in the new command group is created in the
RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS6403 COMMAND GROUP ID MUST BE ENTERED
Cause. While adding a command group, you left the Command Group ID field blank
on your Command Group Definition panel.
Effect. The action is not performed.
Recovery. Specify the name of the command group in the Command Group ID field
before requesting the action again. The name can be up to 12 characters. Valid
characters are alphanumeric characters, @, #, and $. Name of command groups must
be unique: that is, do not specify the name of a command group that already exists in
this ruleset.