NET/MASTER RMS Management and Operations Guide

RMS6505
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–97
RMS6404 COMMAND GROUP ID ALREADY EXISTS
Cause. While adding a command group, you specified the name of a command group
that already exists in this ruleset in the Command Group ID field on your Command
Group Definition panel.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the value in the Command Group ID field to one that is not the
name of an existing command group in this ruleset before requesting the action again.
You can get a list of the existing command groups in this ruleset through option 4
(Command Groups Maintenance) on the Rule Maintenance panel.
RMS6503 MUST BE Y(ES), N(O), INFO, WARN, NORM, OR SER
Cause. You specified an invalid value in the EMS field on your Profile Definition
panel. The action you requested requires a valid value or blank in the EMS field.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of YES, Y, NO, N, INFO, WARN, NORM, or
SER before requesting the action again. If you do not want to change the EMS profile
parameter (which determines whether to receive EMS or PPO messages or not), delete
the value in the EMS field.
RMS6504 MUST BE A SINGLE CHARACTER
Cause. You specified an invalid value in the DELCHAR or NRDELCH field on your
Profile Definition panel. The value must be a single character. The action you
requested requires valid values or blanks in these fields.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to a single character before requesting the action
again. If you do not want to change the characters used in the roll-delete delimiter
line, delete the value in the DELCHAR field; if you do not want to change the
characters used in the non-roll-delete delimiter line, delete the value in the NRDELCH
field.
RMS6505 MUST BE Y(ES), N(O), HM, OR HMS
Cause. You specified an invalid value in the PRFTM field on your Profile Definition
panel. The action you requested requires a valid value or blank in the PRFTM field.
Effect. The value is not accepted. The action is not performed.