NET/MASTER RMS Management and Operations Guide

RMS6506
RMS Messages
A–98 115415 NonStop NET/MASTER RMS Management and Operations Guide
Recovery. Change the invalid value to one of YES, Y, NO, N, HM (hour and minute), or
HMS (hour, minute, and second) before requesting the action again. If you do not
want to change the PRFTM profile parameter (which determines whether to prefix
unsolicited messages with a timestamp), delete the value in the PRFTM field.
RMS6506 GUID MUST BE IN THE FORMAT nnn,nnn
Cause. You specified an improperly formatted value in the GUID field on your Profile
Definition panel.
Effect. The value is not accepted. The action is not performed.
Recovery. Change the value to a valid Guardian user ID before requesting the action
again. The format is “nnn,nnn”, where nnn is in the range 0 through 255. The first
number specifies the group ID and the second number specifies the user ID.
RMS7000 rule-count RULE(S) TRIGGERED
Cause. You selected option 1 (Message Arrival Simulation) on your Event Simulation
panel and started an INT-type message using a specified ruleset. On the Event
Simulation—Message Parameters panels, you defined your simulated message and
pressed F3 to generate the message. The message triggered a number of rules in the
specified ruleset. rule-count is the number of rules triggered.
Effect. The simulated message is processed by the message handler and triggers a
number of rules.
Recovery. This message is informational only; no recovery action is necessary.
RMS7001 NO RULE FOUND
Cause. You performed one of the following:
You selected option 1 (Message Arrival Simulation) on your Event Simulation
panel and started an INT-type message handler using a specified ruleset. On the
Event Simulation—Message Parameters panels, you defined your simulated
message and pressed F3 to generate the message. The message did not trigger any
rules in the specified ruleset.
You selected option 2 (Timer Activation Simulation) on your Event Simulation
panel to test the time-based rules in a specified ruleset. On the Event Simulation—
Time-Based Rules panel, you defined your simulated time and pressed F3 to
generate the time event. The event did not trigger any RMS timers.
Effect. No rules are triggered to perform the rule actions.