Manualshelf

NET/MASTER RMS Management and Operations Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series
411412413414415416417418419420
RMS7018
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–101
RMS7013 (PARTIAL) RULE ID
rule-id
NOT FOUND
Cause. You issued the LOCATE
rule-id
command at the Command prompt on your
Event Simulation—Triggered Actions panel.
rule-id
does not match, either partially
or fully, the name of a triggered rule.
Effect. The list of triggered rules displayed on your panel is unchanged.
Recovery. This message is informational only; no recovery action is necessary.
RMS7014
record-count
RECORDS DELETED
Cause. You typed the D (Del) action code next to one or more message sets on your
Captured Message Set Selection panel, and pressed ENTER to delete the message sets.
You pressed ENTER and confirmed the deletion request.
record-count
is the
number of messages deleted.
Effect. The message set(s) is deleted from the RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS7017
message-count
MESSAGES COPIED TO
message-set-name
Cause. You typed the CP (Copy) action code next to a message set on your Captured
Message Set Selection panel, and pressed ENTER. The action requested that the
messages in the selected message set be copied to another message set. You pressed
ENTER from the inset that appeared and the messages were copied.
message-count
is the number of messages copied
message-set-name
is the name of the message set to which the messages were
copied
Effect. The messages are copied to and saved under the specified message set in the
RMS database.
Recovery. This message is informational only; no recovery action is necessary.
RMS7018 ENTER TARGET SAVE NAME
Cause. You typed the A (Add) or the CP (Copy) action code next to a message set on
your Captured Message Set Selection panel, and pressed ENTER. The action
requested that the messages in the selected message set be copied to a new message set
or an existing message set. RMS prompted you for the name of the message set to
which the messages were to be copied, but you did not specify one.