nld and noft Manual

nld and noft Manual—520384-003
11-1
11 noft Diagnostic Messages
•
Fatal Errors on page 11-1
•
Data Errors on page 11-4
•
Warnings on page 11-18
•
Syntax Errors on page 11-22
The messages are listed in numeric order and grouped by type. Missing numbers in
message sequences are reserved for future development.
Fatal Errors
Cause. noft cannot allocate memory, probably because noft has an internal
problem.
Recovery. Give the object file being examined and the series of commands that you
used to your service provider for analysis.
Cause. noft cannot allocate memory, probably because noft has an internal
problem.
Recovery. Give the object file being examined and the series of commands that you
used to your service provider for analysis.
Cause. This supplementary message follows another fatal error message that
describes the specific nature of the problem.
Recovery. Correct the problem that the other message describes.
Cause. A file input or output error occurred or there is bad end of file.
Recovery. Restart noft and then rebuild the object file.
*** FATAL ERROR *** [1]:
Cannot begin to allocate memory for cross reference data.
*** FATAL ERROR *** [2]:
Cannot finish allocating memory for cross reference data.
*** FATAL ERROR *** [3]:
Do_command was unable to complete the command: command-name.
*** FATAL ERROR *** [4]:
Error reading object file: filename.