nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-14
Data Errors
Cause. FILE or F on page 5-15 encountered a problem when trying to SET
SCOPEPROC, SET SCOPESOURCE, and SET CASE to their defaults.
Recovery. Use RESET on page 5-41 to reset SCOPEPROC, SCOPESOURCE, and CASE
(or all of the SET parameters) to their defaults and then enter the desired new option
value.
Cause. The first or second timestamp of the source files is unavailable.
Recovery. Ensure that the source files are not corrupt.
Cause. noft cannot find an instruction for the opcode at this address.
Recovery. Ensure that noft is looking at a code section with ICODE.
Cause. One of the following has an invalid format:
•
The directory (pathname) specified by CD on page 5-5
•
The system (node-name) or subvolume-name specified by SYSTEM or
VOLUME on page 5-48
Recovery. Ensure that the specified directory, system, or subvolume exists and has
the correct format.
*** DATA ERROR *** [1048]:
Unable to reset option, please reset manually.
*** DATA ERROR *** [1049]:
Unable to retrieve [first|second] timestamp.
*** DATA ERROR *** [1050]:
Unable to scan instructions.
*** DATA ERROR *** [1051]:
Unable to understand that [directory |
[\<node>.][$<volume>.][<subvolume>] ]