nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-15
Data Errors
Cause. noft cannot allocate memory, probably because noft has an internal
problem.
Recovery. Give the object file being examined and the series of commands that you
used to your service provider for analysis.
Cause. Stated in message.
Recovery. Rebuild the object file.
Cause. LISTPROC or LP on page 5-27 could not find the specified address.
Recovery. Use LISTPROC * to find the correct address.
Cause. LISTUNREFERENCED or LUR on page 5-32 was limited by either SET
SCOPEPROC or SET SCOPESOURCE. The number of items found in the scope was
zero.
Recovery. Either use RESET
on page 5-41 to reset the scope to its default or use
SET
on page 5-42 to change the scope. To see the current scope, use SHOW on
page 5-47.
Cause. LISTUNREFERENCED or LUR on page 5-32 was limited by either SET
SCOPEPROC or SET SCOPESOURCE. An error occurred while attempting to display the
information.
Recovery. Use RESET on page 5-41 to reset the scope to its default.
*** DATA ERROR *** [1052]:
Unable to allocate memory for obey file: filename.
*** DATA ERROR *** [1053]:
Cannot dump this ELF file because it has no section headers.
*** DATA ERROR *** [1054]:
Unable to dump specified address because does not exist in
file.
*** DATA ERROR *** [1055]:
Did not find any unreferenced symbols matching scope.
*** DATA ERROR *** [1056]:
Unable to dump some unreferenced item.