nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-16
Data Errors
Cause. LISTSRLFIXUPS or LLF on page 5-30 was limited by either SET SCOPEPROC
or SET SCOPESOURCE. An error occurred while attempting to display the information.
Recovery. Use RESET on page 5-41 to reset the scope to its default.
Cause. LISTPROC or LP on page 5-27 was limited by either SET SCOPEPROC or SET
SCOPESOURCE. No matching information was found.
Recovery. Either use RESET on page 5-41 to reset the scope to its default or use
SET on page 5-42 to change the scope. To see the current scope, use SHOW on
page 5-47.
Cause. The filename in FILE or F on page 5-15 is an archive file.
Recovery. Reissue FILE or F on page 5-15, specifying an ELF file. For archive files,
use the ar program (see Section 6, ar Utility).
Cause. The Guardian file system error number occurred when the Guardian function
FILENAME_DECOMPOSE_ tried to extract the node, volume, and subvolume on the
current directory.
Recovery. Use the SYSTEM or VOLUME on page 5-48 to specify a valid subvolume.
Cause. The Guardian file system error number occurred when the Guardian function
FILENAME_RESOLVE_ tried to build a directory name from existing pieces as a result
of processing the command SYSTEM or VOLUME on page 5-48.
Recovery. Ensure that SYSTEM or VOLUME on page 5-48 specifies a valid node,
volume, and subvolume.
*** DATA ERROR *** [1057]:
Unable to dump srl fixup item.
*** DATA ERROR *** [1058]:
Did not find any procedures matching scope.
*** DATA ERROR *** [1059]:
Unable to handle archive file: filename.
*** DATA ERROR *** [1060]:
The Guardian file system error number number occurred while
trying to prefix the node to the volume and subvolume.
*** DATA ERROR *** [1061]:
The Guardian file system error number number occurred while
trying to construct the filename qualifier.