nld and noft Manual

noft Diagnostic Messages

nld and noft Manual—520384-003

11-18

Warnings

Warnings do not stop noft; therefore, the information under Recovery is merely a

correction you can make to eliminate the problem that causes each warning.

Cause. The specified range of addresses or offsets goes outside the scope of the

procedure.

Recovery. Remove the scoping of the procedure with SET SCOPEPROC * (see SET

on page 5-42). Limit the range within the procedure.

Cause. Stated in message.

Recovery. Use FILE or F on page 5-15 to open an object file and then reissue the

command.

Cause. The specified file was expected to be a COFF file, but it is not.

Recovery. Specify a COFF file.

Cause. The specified object file was created with later versions of native mode

compilers and linker than noft supports; therefore, noft might not understand the

object file format.

Recovery. Use a newer version of noft.

*** WARNING *** [2000]:

End of offset outside of procedure, dumping to end of

procedure.

*** WARNING *** [2001]:

No object file open. No dumping currently possible.

*** WARNING *** [2002]:

Not a Tandem COFF file: filename.

*** WARNING *** [2003]:

Selected file has greater version number than noft.