nld and noft Manual

noft Diagnostic Messages

nld and noft Manual—520384-003

11-22

Syntax Errors

Cause. You can only specify a decimal number for a procedure or source file.

Recovery. Recompute the number in decimal format.

Cause. Either the specified command number is higher than the current command

number or the command number specified is out of the history buffer.

Recovery. Use HISTORY or H on page 5-20 to ensure that the number being entered

is in the current history buffer. To retain more commands, use SET HISTORYBUFFER

(see SET on page 5-42).

Cause. FC 0 does not exist.

Recovery. Choose FC 1 for your first command or FC -1 for the last command

entered (see FC on page 5-14).

Cause. The last address specified is lower than the first address specified.

Recovery. Specify an address range from low address to high address.

Cause. The scope for the procedure or source file previously selected does not

intersect with the address range specified in the last command.

Recovery. Release the scoping restriction previously enabled with

SET SCOPEPROC * or SET SCOPESOURCE * (see SET on page 5-42). Ensure that

the address range is in the procedure or source file.

*** SYNTAX ERROR *** [3000]:

command requires a decimal number.

*** SYNTAX ERROR *** [3001]:

command number Event not found.

*** SYNTAX ERROR *** [3002]:

‘fc <= 0’ does not make sense.

*** SYNTAX ERROR *** [3003]:

Address range not positive, nothing to display.

*** SYNTAX ERROR *** [3004]:

Address range selected not in scope option selected, please

check options.