nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-23
Syntax Errors
Cause. Part of the syntax of an address range is missing.
Recovery. Correct the syntax of DUMPADDRESS or DA on page 5-6.
Cause. Addresses are only 8-digit hexadecimal numbers starting with “0x”. No other
format is supported.
Recovery. Recompute the addresses to hexadecimal in this format.
Cause. An expected address did not start with “0x”.
Recovery. Add “0x” to the address specified. If an address is not expected in that
position, use HELP or ? on page 5-17.
Cause. Bad information was given to the command.
Recovery. Ensure that the syntax of the command is correct.
Cause. This error occurs for the undocumented command RELOC. It indicates that the
procedure given for the SET SCOPEPROC command could not be converted from its
ordinal back to a string.
Recovery. RESET SCOPEPROC might fix the problem (see RESET on page 5-41).
*** SYNTAX ERROR *** [3005]:
Address specification not properly formed.
*** SYNTAX ERROR *** [3006]:
Addresses are in the form 0xXXXXXXXX text.
*** SYNTAX ERROR *** [3007]:
Addresses required to begin with ‘Ox’.
*** SYNTAX ERROR *** [3008]:
Bad parameter to command-name, command ignored.
Note. The next line of the COMMENT command in missing. The COMMENT command in noft is
different from many other HP products.
*** SYNTAX ERROR *** [3009]:
Cannot find name for procedure for option.