nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-24
Syntax Errors
Cause. COMMENT on page 5-5 has reached the end of the file.
Recovery. Retype the comment text.
Cause. noft cannot tell if the option is the one intended; therefore, noft does not
stream large amounts of output.
Recovery. Do not respecify any options or settings that have already been set with
DUMP or LIST.
Cause. The command that you specified immediately after a command whose name
begins with DUMP or LIST was interpreted as an option for the DUMP or LIST
command, and it is not a valid option.
Recovery. Type commands separately or add a semicolon between the commands in
question. For a list of commands that begin with DUMP and LIST, see Table 5-1, noft
Flag Summary, on page 5-1.
Cause. The number of bytes or words specified in an address or offset range must be
in decimal format.
Recovery. Recompute any numbers in decimal format.
Cause. The number specified for HISTORYBUFFER or HISTORYWINDOW is too small
(less than zero) or too large (larger than 32767).
Recovery. Use SET on page 5-42 to specify a buffer or window number from 1 to
32767.
*** SYNTAX ERROR *** [3010]:
Command COMMENT: end of file reached.
*** SYNTAX ERROR *** [3011]:
Command specific option did not change settings, command
aborted.
*** SYNTAX ERROR *** [3012]:
Command specific options not correct, command ignored.
*** SYNTAX ERROR *** [3013]:
FOR requires a decimal number.
*** SYNTAX ERROR *** [3014]:
[HISTORYBUFFER|HISTORYWINDOW] input out of range.