nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-29
Syntax Errors
Cause. This error occurs for several undocumented commands. It indicates that no
information was found in the scope.
Recovery. Either use RESET on page 5-41 to reset the scope to its default or use
SET on page 5-42 to change the scope. To see the current scope, use SHOW on
page 5-47.
Cause. SET FORMAT INNERLIST and a dumping command cannot find the source
file that corresponds with the one specified by the object file in the original or the
current directory.
Recovery. Ensure that the source file exists in either the current directory or in its
original location. To change the current directory or subvolume to where the source file
is located, use the appropriate commands for your environment.
Cause. noft cannot find the specified source filename.
Recovery. Ensure that the specified source file exists and its name is spelled
correctly. Use LISTSOURCE * to see a list of all the source files (see LISTSOURCE or
LS on page 5-29).
Cause. noft cannot find the specified source file number.
Recovery. Ensure that specified procedure exists in object file and the number is in
range. Use LISTSOURCE * to see a list of all the source files (see LISTSOURCE or
LS on page 5-29).
*** SYNTAX ERROR *** [3034]:
Some problem dumping name.
*** SYNTAX ERROR *** [3035]:
Source file filename not in correct position.
Environment Commands
Guardian SYSTEM or VOLUME
on page 5-48
OSS CD
on page 5-5
UNIX CD
on page 5-5
*** SYNTAX ERROR *** [3036]:
Source file name not found, check file descriptor table.
*** SYNTAX ERROR *** [3037]:
Source file number out of range, check file descriptor table.