nld and noft Manual

noft Diagnostic Messages
nld and noft Manual—520384-003
11-31
Syntax Errors
Cause. This error occurs for the undocumented RELOC command. It indicates that a
SET SCOPEPROC command was given but no symbol table was found.
Recovery. Either use RESET on page 5-41 to reset the scope to its default, use SET
on page 5-42 to change the scope, or recompile the module with symbols. To see the
current scope, use SHOW on page 5-47.
Cause. The parameter to HELP does not match any current help topics.
Recovery. Use HELP or HELP ALL for a list of HELP commands (see HELP or ? on
page 5-17).
Cause. noft cannot find a command with the specified name.
Recovery. Use HELP ALL to ensure that the command is available and spelled
correctly (see HELP or ? on page 5-17).
Cause. This error occurs for the undocumented GINFOSITE and SRLINFO
commands. It indicates that no information was found within the limits of the scope.
Recovery. Either use RESET on page 5-41 to reset the scope to its default or use
SET on page 5-42 to change the scope. To see the current scope, use SHOW on
page 5-47.
Cause. The command number was in range, but the line was unavailable.
Recovery. Use HISTORY or H on page 5-20 to see if the command can be seen and
if so, retype the command.
*** SYNTAX ERROR *** [3043]:
Unable to find ELF symbol to correspond with correct
procedure.
*** SYNTAX ERROR *** [3044]:
Unable to find HELP topic.
*** SYNTAX ERROR *** [3045]:
Unable to find command: command.
*** SYNTAX ERROR *** [3046]:
Unable to find end of name, command ignored.
*** SYNTAX ERROR *** [3047]:
Unable to find in-range line number in history.