noft Manual (G06.26+)

noft Diagnostic Messages
noft Manual—528273-001
4-18
Warnings
Cause. You used LISTUNREFERENCED or LUR on page 3-33 while SET
SCOPEPROC was active. These commands are incompatible. If the scope has been set
to a specific procedure, the procedure must be resolved. Rather than show an empty
list, noft issues this error so that you can reset the scope and reissue the command.
Recovery. Remove the scoping of the procedure with SET SCOPEPROC * (see SET
on page 3-43).
Warnings
Warnings do not stop noft; therefore, the information under Recovery is merely a
correction you can make to eliminate the problem that causes each warning.
Cause. The specified range of addresses or offsets goes outside the scope of the
procedure.
Recovery. Remove the scoping of the procedure with SET SCOPEPROC * (see SET
on page 3-43). Limit the range within the procedure.
Cause. Stated in message.
Recovery. Use FILE or F on page 3-16 to open an object file, and then reissue the
command.
Cause. The specified file was expected to be a COFF file, but it is not.
Recovery. Specify a COFF file.
*** DATA ERROR *** [1065]:
RESET SCOPEPROC before using LISTUNRESOLVED command.
*** WARNING *** [2000]:
End of offset outside of procedure, dumping to end of
procedure.
*** WARNING *** [2001]:
No object file open. No dumping currently possible.
*** WARNING *** [2002]:
Not a Tandem COFF file: filename.