noft Manual (G06.26+)
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- 2 noft Utility
- 3 noft Options
- Break Key
- ! (Exclamation Point)
- CD
- COMMENT
- DUMPADDRESS or DA
- DUMPOFFSET or DO
- DUMPPROC or DP
- DYNSTR2
- ENV
- EXIT or E
- FC
- FILE or F
- HELP or ?
- HISTORY or H
- LAYOUT
- LIBLIST
- LISTATTRIBUTE or LA
- LISTCOMPILERS or LC
- LISTOPTIMIZE or LO
- LISTPROC or LP
- LISTSOURCE or LS
- LISTSRLEXPORTS or LLE
- LISTSRLFIXUPS or LLF
- LISTSRLINFO or LLI
- LISTUNREFERENCED or LUR
- LISTUNRESOLVED or LU
- LOG
- OBEY
- OUT
- QUIT or Q
- RESET
- SET
- SHOW
- SYSTEM or VOLUME
- XREFPROC or XP
- 4 noft Diagnostic Messages
- 5 ar Utility
- 6 ar Diagnostic Messages
- A Sample nld and noft Session
- B Converting From Binder to noft
- C Native Object File Structure
- Glossary
- Index
noft Diagnostic Messages
noft Manual—528273-001
4-20
Warnings
Cause. LISTPROC or LP on page 3-28 or XREFPROC or XP on page 3-50 could not
find the specified procedure.
Recovery. Use LISTPROC * or XREFPROC * to see what procedures are available.
Cause. In the Guardian environment, you used one of:
•
INNERLIST option of DUMPADDRESS or DA on page 3-6
•
DUMPOFFSET or DO on page 3-8
•
DUMPPROC or DP on page 3-10
Recovery. Use LISTPROC or LP on page 3-28 with the DETAIL option to see the
name of the source file. Verify that the source file is the same edit file that was used
when the module was compiled. Verify that the current default subvolume does not
have a file with the same file name.
Cause. The filename in FILE or F on page 3-16 is on a remote node. The data
must be transferred from the remote node to the noft execution node. For large files,
transfer might take a few minutes, but after the data transfer, will have no further
delays.
Recovery. If numerous FILE commands will be done for files on a remote node, it
might be faster to execute noft on the remote node.
Cause. This error can occur only in the Guardian environment.
Recovery. Check the result in the Guardian Procedure Calls Reference Manual
(see SEGMENT_ALLOCATE_). Based on that information, take appropriate action.
*** WARNING *** [2008]:
No cross reference information available in this category for
procedure procedure-name.
*** WARNING *** [2009]:
Cannot convert line number to Tandem edit line number.
*** WARNING *** [2010]:
Command execution time is increased when object file is on
different node.
*** WARNING *** [2011]:
SEGMENT_ALLOCATE_ had the following result: result