noft Manual (G06.26+)
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- 2 noft Utility
- 3 noft Options
- Break Key
- ! (Exclamation Point)
- CD
- COMMENT
- DUMPADDRESS or DA
- DUMPOFFSET or DO
- DUMPPROC or DP
- DYNSTR2
- ENV
- EXIT or E
- FC
- FILE or F
- HELP or ?
- HISTORY or H
- LAYOUT
- LIBLIST
- LISTATTRIBUTE or LA
- LISTCOMPILERS or LC
- LISTOPTIMIZE or LO
- LISTPROC or LP
- LISTSOURCE or LS
- LISTSRLEXPORTS or LLE
- LISTSRLFIXUPS or LLF
- LISTSRLINFO or LLI
- LISTUNREFERENCED or LUR
- LISTUNRESOLVED or LU
- LOG
- OBEY
- OUT
- QUIT or Q
- RESET
- SET
- SHOW
- SYSTEM or VOLUME
- XREFPROC or XP
- 4 noft Diagnostic Messages
- 5 ar Utility
- 6 ar Diagnostic Messages
- A Sample nld and noft Session
- B Converting From Binder to noft
- C Native Object File Structure
- Glossary
- Index
noft Options
noft Manual—528273-001
3-11
DUMPPROC or DP
Considerations:
•
The range of offsets must appear entirely within one of the specified
procedures. If the offset range is outside the procedure, the output stops at the
end of the procedure and noft emits an error message.
•
The address of a code section is rounded up to a whole number of words.
format-specifier
specifies how the information is to be formatted. format-specifier is one of:
{ ASCII | A }
displays portions of the object file in ASCII format.
{ DECIMAL | D }
displays portions of the object file in decimal format.
{ HEX | H }
displays portions of the object file in hexadecimal format.
{ ICODE | IC }
displays portions of the object file in disassembled program code. This is the
default.
{ INNERLIST | IN }
displays portions of the object file in disassembled program code and displays
the source code interspersed with the code. Use this option for displaying text.
{ OCTAL | O }
displays portions of the object file in octal format.
If you do not specify the format with the DUMPPROC option, the formatting is
controlled by the SET FORMAT option (see SET on page 3-43).