noft Manual (G06.26+)

noft Diagnostic Messages
noft Manual—528273-001
4-14
Data Errors
Cause. Either the loadfile is stripped, or the procedure table is corrupted.
Recovery. Rebuild the loadfile without stripping.
Cause. FILE or F on page 3-16 encountered a problem when trying to SET
SCOPEPROC, SET SCOPESOURCE, and SET CASE to their defaults.
Recovery. Use RESET on page 3-42 to reset SCOPEPROC, SCOPESOURCE, and CASE
(or all the SET parameters) to their defaults, and then enter the desired new option
value.
Cause. The first or second timestamp of the source files is unavailable.
Recovery. Verify that the source files are not corrupt.
Cause. noft cannot find an instruction for the opcode at this address.
Recovery. Verify that noft is looking at a code section with ICODE.
Cause. One of these has an invalid format:
•
The directory (pathname) specified by CD on page 3-5
•
The system (node-name) or subvolume-name specified by SYSTEM or
VOLUME on page 3-49
Recovery. Verify that the specified directory, system, or subvolume exists and has the
correct format.
*** DATA ERROR *** [1047]:
Unable to read table-name procedure table, command ignored.
*** DATA ERROR *** [1048]:
Unable to reset option, please reset manually.
*** DATA ERROR *** [1049]:
Unable to retrieve [first|second] timestamp.
*** DATA ERROR *** [1050]:
Unable to scan instructions.
*** DATA ERROR *** [1051]:
Unable to understand that [directory |
[\<node>.][$<volume>.][<subvolume>] ]