noft Manual (G06.27+, H06.03+, J06.03+)

noft Diagnostic Messages
noft Manual—528273-003
4-19
Warnings
1063
Cause. During construction of a Guardian file name from components, the file system
error number occurred.
Recovery. Use SYSTEM or VOLUME on page 3-52 to change to a subvolume with a
shorter name. If this error still occurs, contact your service provider.
1064
Cause. This internal error occurs during construction of a Guardian file name from
components. The length of the path name plus the length of the file name was too long
for the destination array. Only the file name part will be used.
Recovery. Use CD on page 3-5 to set a shorter pathname.
1065
Cause. You used LISTUNREFERENCED or LUR on page 3-35 while SET
SCOPEPROC was active. These commands are incompatible. If the scope has been set
to a specific procedure, the procedure must be resolved. Rather than show an empty
list, noft issues this error so that you can reset the scope and reissue the command.
Recovery. Remove the scoping of the procedure with SET SCOPEPROC * (for more
information, see SET on page 3-47).
Warnings
Warnings do not stop noft; therefore, the information under Recovery is merely a
correction you can make to eliminate the problem that causes each warning.
*** DATA ERROR *** [1063]:
The Guardian file system error number number occurred while
manipulating file name components.
*** DATA ERROR *** [1064]:
The path length exceeds the container size of number.
*** DATA ERROR *** [1065]:
RESET SCOPEPROC before using LISTUNRESOLVED command.