noft Manual (G06.27+, H06.03+, J06.03+)

noft Diagnostic Messages
noft Manual—528273-003
4-28
Syntax Errors
3017
Cause. LISTOPTIMIZE or LO on page 3-29 has an invalid level.
Recovery. Reissue LISTOPTIMIZE, using a valid level.
3018
Cause. noft cannot determine the specified parameter.
Recovery. Correct the command syntax; specifically, the parameter descriptions.
3019
Cause. noft cannot determine the specified command.
Recovery. Correct the command syntax.
3020
Cause. A parameter is missing for the specified command.
Recovery. Correct the command syntax; specifically, the parameter descriptions.
3021
Cause. This error occurs for the undocumented SRLINFO command. It indicates that
no information was returned for the range restricted by either SET SCOPESOURCE or
SET SCOPEPROC.
Recovery. Either use RESET on page 3-44 to reset the scope to its default or use
SET on page 3-47 to change the scope. To see the current scope, use SHOW on
page 3-52.
*** SYNTAX ERROR *** [3017]:
Invalid optimization level specified.
*** SYNTAX ERROR *** [3018]:
Invalid parameter to command, command ignored
*** SYNTAX ERROR *** [3019]:
command command not properly formed.
*** SYNTAX ERROR *** [3020]:
Missing parameter to command, command ignored.
*** SYNTAX ERROR *** [3021]:
No SRL references in procedure, command ignored.