noft Manual (G06.27+, H06.03+, J06.03+)

noft Diagnostic Messages
noft Manual—528273-003
4-31
Syntax Errors
number of the source file. (For more information, see LISTPROC or LP on page 3-30
and SET on page 3-47.)
3030
Cause. noft cannot find the specified procedure number.
Recovery. Verify that the specified procedure exists in the object code file and that its
name is spelled correctly. Use LISTPROC * SET SCOPESOURCE source-file,
where source-file is the name of the source file that contains the procedure or the
number of the source file. (For more information, see LISTPROC or LP on page 3-30
and SET on page 3-47.)
3031
Cause. noft does not allow OBEY command files to call themselves recursively
(circularly).
Recovery. Remove the loop in the OBEY command files.
3032
Cause. SET requires arguments, but it has none.
Recovery. Reenter SET correctly (for more information, see SET
on page 3-47).
3034
Cause. This error occurs for several undocumented commands and indicates that no
information was found in the scope.
Recovery. Either use RESET on page 3-44 to reset the scope to its default or use
SET on page 3-47 to change the scope. To see the current scope, use SHOW on
page 3-52.
*** SYNTAX ERROR *** [3030]:
Procedure number out of range, check procedure descriptor table.
*** SYNTAX ERROR *** [3031]:
Recursive obey names: filename.
*** SYNTAX ERROR *** [3032]:
SET should not be used by itself, check HELP SET for more
details.
*** SYNTAX ERROR *** [3034]:
Some problem dumping name.