noft Manual (G06.27+, H06.03+, J06.03+)

ar Diagnostic Messages
noft Manual—528273-003
6-4
Recovery. Retry the command when there are fewer active processes in the system,
or break up a large archive into smaller archives.
Cause. ar cannot obtain additional memory space for the symbol table. The archive, if
created, will not be usable by nld.
Recovery. Break the archive into several smaller archives.
Cause. ar detected inconsistencies in the object code file member and cannot finish
its operation. The archive symbol table is unusable by nld.
Recovery. Either remove the object code file member from the archive or obtain a
valid copy of the object code file and repeat the ar operation.
Cause. An error occurred during the operation; for example, a member file cannot be
found. The archive symbol table contained in the archive might have been corrupted or
might not contain up-to-date information required by nld for resolving external
references.
Recovery. Identify the source of the error and remedy the situation so that the archive
operation can be finished normally. You can also use the -s option to restore or
regenerate the symbol table.
Cause. During an extract (-x) operation, the file name of the specified file is longer
than the maximum supported by the file system. The specific member is not extracted.
Recovery. Use the -T option to truncate the file name to the maximum length allowed
by the File System during extraction.
Effect. The identified option combination is not allowed.
Recovery. Reenter the command correctly.
cannot realloc space.
corrupted object file filename.
error during operation, archive archive may not contain
correct symbol table usable by the binder/nld.
file name filename: filename too long for filesystem.
illegal option combination for option.