NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-25
Messages
Unconditional Tokens
Cause. The most likely cause is that the device is not connected to the SCSI bus. If
the device is connected to the SCSI bus, the cause is a device, SCSI bus, or controller
error.
Effect. The command cannot be completed.
Recovery. Check the device.
193: ZSMD-EVT-DEV-CMD-TIMEOUT
A SCSI command to a device did not finish in time.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Device Selection Timeout
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-DEV-
SEL-TIMEOUT (192).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Device Command Timeout