NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-28
Messages
196: ZSMD-EVT-DEV-SCSI-STATUS
The device SCSI status was not expected.
Unconditional Tokens
Cause. A device hardware problem or a SCSI module driver programming error has
occurred. The ZSMD-TKN-AST-ISP-STATUS contains the received SCSI status.
Effect. The command cannot be completed.
Recovery. This is an informational message only; no corrective action is needed. The
device input/output process (IOP) will retry the command.
197: ZSMD-EVT-DEV-INTF-ERR
A device interface error occurred.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Device SCSI Status
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-DEV-
SCSI-STATUS (196).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes