NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-31
Messages
Recovery. This is an informational message only; no corrective action is needed. The
device IOP will retry the command.
256: ZSMD-EVT-CTLR-DISABLED
The controller was disabled.
Unconditional Tokens
Cause. The controller is not available or it has caused too many interrupts.
Effect. The path from the processor to the devices attached to the controller is lost.
Recovery. Check the controller hardware.
257: ZSMD-EVT-CTLR-ACCESS-NOT-ESTB
Controller access from the processor is not established.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Controller Disabled
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-DISABLED (256).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes