NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-37
Messages
Unconditional Tokens
Cause. A controller has detected that the SCSI bus is hung.
Effect. Commands to the devices on the SCSI bus have been aborted.
Recovery. This is an informational message only; no corrective action is needed.
304: ZSMD-EVT-CTLR-INTF-ERR
A controller interface error occurred.
Unconditional Tokens
Cause. A controller problem has occurred.
Effect. The command cannot be completed.
Recovery. This is an informational message only; no corrective action is needed. The
device input/output process (IOP) will retry the command.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-SCSI-
BUS-RESET-IN (289).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Controller Interface Error
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-INTF-ERR (304).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.