NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-40
Messages
Unconditional Tokens
Cause. The controller has reset either a device or the SCSI bus.
Effect. None. This is an indication of some other event.
Recovery. This is an informational message only; no corrective action is needed.
308: ZSMD-EVT-CTLR-SVT-ERROR
The processor’s initial attempt to access the controller resulted in a ServerNet error.
Unconditional Tokens
Cause. The controller has not been configured correctly by XIOMON.
Effect. The path from the processor to the devices attached to the controller is lost.
Recovery. Check the configuration.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-ASYNC-INTR (307).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: Yes
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Controller SVT Error
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-SVT-ERROR (308).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.