NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-45
Messages
Unconditional Tokens
Cause. A configuration error has occurred. Either too many processors accessed the
controller or a SCSI module driver programming error has occurred.
Effect. The paths from the processor to the devices attached to the controller are lost.
Recovery. Check the configuration.
315: ZSMD-EVT-CTLR-FW-CHECK-ERR
During controller download, verify checksum command resulted in an error.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Controller Servernet Handle Error
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-SVNET-HNDL-ERR (314).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Controller Firmware Check Error