NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-46
Messages
Unconditional Tokens
Cause. A firmware file error, controller memory error, or transfer error has occurred.
Effect. The controller download has failed. Repeated failures will cause the paths from
the processor to the devices attached to the controller to become lost.
Recovery. This is an informational message only; no corrective action is needed. The
device input/output process (IOP) will retry downloading the controller.
992: ZSMD-EVT-CMD-ABORT
The command was aborted by the Module Driver, the controller, or the device because
of an unrelated cause.
Unconditional Tokens
Cause. Possible causes are a SCSI bus reset, a device reset, a controller error, or a
ServerNet error.
Effect. The command cannot be completed.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
CTLR-FW-CHECK-ERR (315).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI Command Aborted
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-CMD-
ABORT (992).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.