NonStop Operating System Event Management Programming Manual

Storage Subsystem Event Messages (ZSTO)
HP NonStop Operating System Event Management Programming Manual—520372-020
23-4
1033: ZSTO-EVT-CRU-INIT-FAILED The storage subsystem manager failed
to initialize a CRU. The event contains
the error number returned from the
support function used (provided by either
the SIFM or the extensible I/O (XIO)
product.
1034: ZSTO-EVT-POST-COMPLETE
The storage subsystem manager has
determined that the power-on-self-test
has finished successfully for a CRU that
was inserted.
1035: ZSTO-EVT-POST-FAILED
The storage subsystem manager
determined that the power-on-self-test
failed for a CRU that was inserted.
1036: ZSTO-EVT-CHECKSUM
The storage subsystem manager
recomputed and corrected sector
checksum values for a range of disk
addresses.
1037: ZSTO-EVT-INVALID-CRU
The storage subsystem manager could
not obtain enough information to
determine what type of CRU was
inserted or how to configure the CRU.
1038: ZSTO-EVT-SERVER-ERROR
The storage subsystem manager
detected a server access error.
1039: ZSTO-EVT-PROCESS-IO-ERROR
The storage subsystem manager
detected a process startup I/O error.
1040: ZSTO-EVT-UNSUPPORTED-CRU
The storage subsystem manager
received a hardware insertion event for a
CRU it does not support.
1041: ZSTO-EVT-CRU-OWNERSHIP
The storage subsystem manager
detected that it cannot configure a CRU
because the slot where the CRU was
inserted is already configured by another
subsystem.
1042: ZSTO-EVT-CRU-DELETED
The storage subsystem manager has
deleted a CRU’s configurations from the
system configuration database.
1043: ZSTO-EVT-TASK-ERROR
The storage subsystem manager
detected that an internal task failed.
1044: ZSTO-EVT-IOP-LAUNCH
The storage subsystem manager reports
that an input/output process (IOP) was
launched.
Table 23-1. Storage Subsystem Event Messages (page4of7)
Event Number and Symbolic Name Description