NonStop Operating System Event Management Programming Manual

Storage Subsystem Event Messages (ZSTO)
HP NonStop Operating System Event Management Programming Manual—520372-020
23-5
1045: ZSTO-EVT-CRU-CONFIG-FAILED The storage subsystem manager failed
to autoconfigure a CRU. The event
contains information describing the
reason for the failure.
1046: ZSTO-EVT-CRU-ACCESS-ERROR
The storage subsystem manager failed
to obtain CRU information.
1047: ZSTO-EVT-CRU-RECONFIG
The storage subsystem manager has
changed the configuration for a CRU.
1048: ZSTO-EVT-CONFIG-DEFERRED
The storage subsystem manager has
deferred the configuration of a CRU. This
event is generated when the storage
profile record forces the storage
subsystem manager to start the I/O
process to complete the configuration of
the CRU and the processors in which the
I/O process is configured to run.
1049: ZSTO-EVT-BACKUP-START-ERROR
The storage subsystem encountered an
error while attempting to notify a primary
disk to launch its backup process.
1050: ZSTO-EVT-REPLACE
A user issued an SCF REPLACE DISK
command.
1051: ZSTO-EVT-ACCESS-LIST
The storage subsystem manager has
updated the configuration record of an
adapter with a new processor access list.
1052: ZSTO-EVT-LABEL-COMMAND
An SCF LABEL command has been
executed.
1053: ZSTO-EVT-EJECT
An SCF EJECT command has been
executed.
1054: ZSTO-EVT-FIRMWARE-DIFFERENT
Two different versions of the same
firmware type are in use.
1055: ZSTO-EVT-ABANDON-FW A replace adapter firmware procedure
that was in progress has been
abandoned.
1056: ZSTO-EVT-IOP-ACCESS-FAILED
A SCSI command to a device failed.
1057: ZSTO-EVT-POWER-ACTION
The storage subsystem manager turned
the power to a device on or off.
2001: ZSTO-EVT-CNFG-DISK-NAME
The storage subsystem manager has
been informed that a disk has changed
its name automatically.
Table 23-1. Storage Subsystem Event Messages (page5of7)
Event Number and Symbolic Name Description