NonStop Operating System Event Management Programming Manual

Configuration Services Event Messages (ZDSC)
HP NonStop Operating System Event Management Programming Manual—520372-020
24-11
Messages
Unconditional Tokens
Cause. A software or hardware fault prevented the configuration utility process
($ZCNF) from launching $ZPM.
This could occur either when the system is loaded or during normal functioning of the
system. The process launch errors reported in the event log indicate the reason for
failure.
Effect. If a system load is in progress, $ZCNF will halt the processor with %7703 halt
code. Otherwise $ZCNF will retry up to three times. If it still fails to start $ZPM, $ZCNF
will wait for 10 minutes before attempting to restart $ZPM again.
Recovery. $ZCNF attempts to restart $ZPM at regular intervals, and once $ZPM is
started, a corresponding EMS event is logged. But if this doesn’t happen or a
processor halt occurs during system load, see Recovery Action Requiring Vendor
Support on page 24-10.
1025: ZDSC-EVT-ZPM-PROCESS-STOPPED
The persistence manager process ($ZPM) was stopped unexpectedly.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSC-
EVT-ZPM-STARTUP-FAILURE (1024).
ZDSC-TKN-PROC-LAUNCH-ERR Error that occurred during the process launch.
Value is ZDSC-TNM-PROC-LAUNCH-ERR.
ZDSC-TKN-PROC-LAUNCH-ERR-DETL Detailed error information about the failed
launch. Value is ZDSC-TNM-PROC-LAUNCH-
ERR-DETL.
Potentially critical event: No
Action event: No
Message sender: $ZCNF
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZDSC-TKN-PROC-DEATH-CCODE token-type ZSPI-TYP-INT
ZDSC-TKN-PROC-DEATH-TCODE token-type ZSPI-TYP-INT
ZDSC-TKN-PROC-DEATH-TEXT token-type ZSPI-TYP-STRING
Event-Message Text
Persistence manager process ($ZPM) stopped
Completion code:proc-death-ccode
Termination code:proc-death-tcode
Termination text: proc-death-text