NonStop Operating System Event Management Programming Manual

Complex Manager Auxiliary Process (CMAP) Event
Messages (ZCMP)
HP NonStop Operating System Event Management Programming Manual—520372-020
25-4
214: ZCMP-EVT-ECHO-CABLING-VALID* An invalid reintegration cabling
configuration became valid.
215: ZCMP-EVT-ECHO-SCRUB-ERROR
FPGA 3 scrub error.
216: ZCMP-EVT-LID-CHANGED
* Local interrupt ID (LID) of one PE in a
processor changed.
217: ZCMP-EVT-LSU-CHANGED
* Logical synchronization unit (LSU) status
changed.
218: ZCMP-EVT-SLICE-CHANGED
A NonStop Blade Element tracking ID
changed.
219: ZCMP-EVT-SLICE-NO-PES
* No PEs on a NonStop Blade Element are
responding.
220: ZCMP-EVT-SLICE-MEM-SIZE
* NonStop Blade Elements in a NonStop
Blade Complex have different memory
sizes.
221: ZCMP-EVT-ECHO-CONNECT-ERR
One or more reintegration cables is either
missing, broken, or connected to a
NonStop Blade Element that is not
operating.
222: ZCMP-EVT-COMPLEX-INVALID-6
A NonStop Blade Complex is invalid
because its NonStop Blade Elements
report different numbers of PEs.
223: ZCMP-EVT-COMPLEX-INVALID-7
A NonStop Blade Complex is invalid
because two processors report the same
LID for a given NonStop Blade Element.
224: ZCMP-EVT-ECHO-CRAM-ERROR
A NonStop Blade Complex is invalid
because two processors report the same
LID for a given NonStop Blade Element.
300: ZCMP-EVT-SLICE-PWR-REDUNDANCY
* Power supply redundancy status changed.
301: ZCMP-EVT-SLICE-ESC-CHANGE
* Environmental sense and control (ESC)
status changed.
302: ZCMP-EVT-SLICE-LED-CHANGE
* LED status changed.
303: ZCMP-EVT-LSU-PWR-STATUS
* Power supply status changed.
304: ZCMP-EVT-LSU-LED-CHANGE
Fault LED status changed.
400: ZCMP-EVT-FIRMW-SCRUB-START
Firmware scrub started.
401: ZCMP-EVT-FIRMW-SCRUBBED
Firmware scrub completed.
402: ZCMP-EVT-FIRMW-UPDATE-START
Firmware update started.
403: ZCMP-EVT-FIRMW-UPDATE-DONE
Firmware update completed.
404: ZCMP-EVT-FIRMW-UPDATE-FAILED
Firmware update program failed during a
scrub or update.
Table 25-2. ZCMP Event Messages (page 4 of 5)
* Both $ZLOG and $0 report this event to the EMS.