NonStop Operating System Event Management Programming Manual

Complex Manager Auxiliary Process (CMAP) Event
Messages (ZCMP)
HP NonStop Operating System Event Management Programming Manual—520372-020
25-5
Common Definitions
Topics:

Common Definitions on page 25-5

Description of ZCMP Event Messages on page 25-8
Common Definitions
Common definitions are definitions that are used in several (usually three or more)
event messages for a specific subsystem or system component. The ZCMP event
messages use definitions from the following sources:

Subsystem Programmatic Interface (SPI) Standard Definitions on page 25-6

Event Management Service (EMS) Standard Definitions on page 25-7

Configuration Services (ZCMP-) Definitions on page 25-7
A general description of these definitions is provided in the following paragraphs.
500: ZCMP-EVT-RCVDUMP-FAILURE A PE’s scheduled receive dump either
failed to launch or failed after being
launched.
600: ZCMP-EVT-SAD-PROCESS-FAILED
Slow Access Device (SAD) process either
could not be launched or failed after being
launched.
Note. The event-message header tokens are described in Section 2, Header and Common
Tokens.
Note. All definitions are shown in DDL format using hyphens (-) as separators. If you are
programming in TAL or TACL, substitute the circumflex symbol (^) for the hyphens. If you are
programming in Pascal or C, substitute the underscore symbol (_) for the hyphens. For a quick
explanation of DDL, see the SPI Programming Manual.
Table 25-2. ZCMP Event Messages (page 5 of 5)
* Both $ZLOG and $0 report this event to the EMS.