NonStop Operating System Event Management Programming Manual

Interprocessor Bus Event Messages (ZIPB)
HP NonStop Operating System Event Management Programming Manual—520372-020
4-11
Messages
Unconditional Tokens
Cause. An operator issued the XBUSUP or YBUSUP command to enable the bus
between the sender processor (ZIPB-TKN-CPU) and the processor indicated by ZIPB-
TKN-RPTCPU. The operating system restores the bus to operation.
Effect. The system reports the event and continues processing.
Recovery. This is an informational message only; no corrective action is needed.
105: ZIPB-EVT-BUSMISC
Bus receive sequence errors or unexpected packets were received from a processor.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZIPB-TKN-BUS token-type ZSPI-TYP-BYTE
ZIPB-TKN-CPU token-type ZSPI-TYP-UINT
ZIPB-TKN-RPTCPU token-type ZSPI-TYP-UINT
Event-Message Text
CPU nn : BUS {X|Y} UP TO PROCESSOR
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZIPB-EVT-BUSUP
(104).
ZIPB-TKN-BUS Is the subject token that specifies the bus. Value is either 0
(X bus) or 1 (Y bus).
ZIPB-TKN-CPU Processor number of the processor reporting the event.
This processor brought up the bus to ZIPB-TKN-RPTCPU.
ZIPB-TKN-RPTCPU Processor number of the processor to which the bus was
brought up. (It is not the processor reporting the event.)
Subject: ZIPB-TKN-BUS
Potentially critical event: Yes
Action event: No
Message sender: Monitor process
TMDS collector: Yes