NonStop Operating System Event Management Programming Manual

Interprocessor Bus Event Messages (ZIPB)
HP NonStop Operating System Event Management Programming Manual—520372-020
4-15
Messages
108: ZIPB-EVT-EXCESIVEOUTQTIMEOUTS
The OUTQ timed out in a NonStop™ VLX, NonStop™ CLX, or NonStop™ Cyclone
system.
Unconditional Tokens
Cause. An excessive number of OUTQ timeouts have occurred.
Effect. The faulty bus (given by ZIPB-TKN-BUS) is marked as bad and is no longer
used for sending messages. The operating system shuts down the bus to all the
processors and issues the ZIPB-EVT-BUSDOWN (101) event message.
Recovery. Normally, no corrective action is needed. If the error continues to occur,
see Recovery Action Requiring Vendor Support
on page 4-6.
Subject: ZIPB-TKN-BUS
Potentially critical event: No
Action event: No
Message sender: Monitor process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZIPB-TKN-BUS token-type ZSPI-TYP-BYTE
ZIPB-TKN-CPU token-type ZSPI-TYP-UINT
ZIPB-TKN-OUTQTIMEOUTS token-type ZSPI-TYP-UINT
ZIPB-TKN-RPTCPU token-type ZSPI-TYP-UINT
Event-Message Text
CPU nn : BUS {X|Y} EXCESSIVE TIMEOUTS ON OUT QUEUE
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZIPB-EVT-
EXCESIVEOUTQTIMEOUTS (108).
ZIPB-TKN-BUS Is the subject token that specifies the bus. Value is either 0
(X bus) or 1 (Y bus).
ZIPB-TKN-CPU Processor number of the processor reporting the error.
ZIBP-TKN-OUTQTIMEOUTS Number of timeouts.
ZIPB-TKN-RPTCPU Processor number of the processor reporting the bus error;
it is the sending processor (same as ZIPB-TKN-CPU).