NonStop Operating System Event Management Programming Manual

Interprocessor Bus Event Messages (ZIPB)
HP NonStop Operating System Event Management Programming Manual—520372-020
4-17
Messages
Effect. None.
Recovery. Normally, no recovery action is necessary. If the error continues to occur,
see Recovery Action Requiring Vendor Support on page 4-6.
110: ZIPB-EVT-BUSCTRLPARITYERROR
A reset or a parity error occurred on the control lines from the bus controller on a
Cyclone or K10000 processor.
Unconditional Tokens
Cause. The IPB interface on the specified Cyclone or K10000 processor encountered
either a parity error or a reset on the control lines from the bus controller.
Subject: ZIPB-TKN-BUS
Potentially critical event: No
Action event: No
Message sender: Monitor process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZIPB-TKN-BUS token-type ZSPI-TYP-BYTE
ZIPB-TKN-CPU token-type ZSPI-TYP-UINT
ZIPB-TKN-RPTCPU token-type ZSPI-TYP-UINT
ZIPB-TKN-CTRLPARITYERRORS token-type ZSPI-TYP-UINT
Event-Message Text
CPU nn : BUS {X|Y} : nn PARITY OR RESET ERRORS IN BUS
CONTROLLER.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZIPB-EVT-
BUSCTRLPARITYERROR (110).
ZIPB-TKN-BUS Is the subject token that specifies the bus. Value is
either 0 (X bus) or 1 (Y bus).
ZIPB-TKN-CPU Processor number of the processor that reported the
error.
ZIPB-TKN-RPTCPU Processor number of the processor whose IPB
reported the problem (same as ZIPB-TKN-CPU).
ZIPB-TKN-CTRLPARITYERRORS Number of times the IPB interface reported either a
reset or a parity error on the control lines from the bus
controller.