NonStop Operating System Event Management Programming Manual

Complex Manager Auxiliary Process (CMAP) Event
Messages (ZCMP)
HP NonStop Operating System Event Management Programming Manual—520372-020
25-101
Messages
Cause. Either a hardware error or an improperly programmed NonStop Blade Element
tracking ID (two physical NonStop Blade Elements have the same tracking ID). One of
the two reported processors is defective, but it is impossible to identify which one.
Effect. CMAP cannot reintegrate or reset any NonStop Blade Element connected to
the NonStop Blade Complex.
Recovery. Contact your service provider.
224: ZCMP-EVT-ECHO-CRAM-ERROR
Corruption of the RAM used to configure hardware logic on the memory reintegration
board was detected on a slice.
ZCPU-TKN-LID Subject token that specifies the LID that two processors
report.
ZCPU-TKN-CPU(0) Subject token that specifies the first processor that
reports the LID.
ZCPU-TKN-SLICEID NonStop Blade Element ID of the NonStop Blade
Element for ZCPU-TKN-CPU(0).
ZCPU-TKN-CPU(1) Subject token that specifies the second processor that
reports the LID.
ZCPU-TKN-SLICEID1 NonStop Blade Element ID of the affected NonStop
Blade Element for ZCPU-TKN-CPU(1).
Potentially critical event: No
Action event: No
Message sender: CMAP
$ZLOG: Yes
$0: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-EMPHASIS token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ISO-SEVERITY token-type ZSPI-TYP-ISOSEVERITY
ZCMP-TKN-COMPLEX-ID token-type ZSPI-TYP-INT
ZCPU-TKN-SLICEID <1> token-type ZSPI-TYP-BYTE
ZCPU-TKN-SLICE-TRACKING-ID <2> token-type ZSPI-TYP-STRING
ZCPU-TKN-ECHO-ERROR-0 <3> token-type ZSPI-TYP-INT4
ZCPU-TKN-ECHO-ERROR-1 <4> token-type ZSPI-TYP-INT4
ZCPU-TKN-ECHO-ERROR-2 <5> token-type ZSPI-TYP-INT4
ZCPU-TKN-CALL-DEV <6> token-type ZSPI-TYP-BYTE
Token Description (page 2 of 2)