NonStop Operating System Event Management Programming Manual

Dynamic Link Library (DLL) Event Messages (ZDLL)
HP NonStop Operating System Event Management Programming Manual—520372-020
26-9
Messages
Cause. Either:

The required public DLL was not specified in the ZREG file.

The required public DLL was specified incorrectly in the ZREG file (as message
107: ZDLL-EVT-PARSER on page 26-21 might report).

An error (which message 102: ZDLL-EVT-DLL-FAIL on page 26-10 reports)
occurred while preloading the required public DLL.
Effect. The required public DLL is not preloaded. Files of the type indicated by ZDLL-
TKN-PROGTYPE cannot run on this processor. The processor halts with halt code
%5030, %5031, %5032, or %5033.
Recovery. If the problem occurred while loading the system, revert to a previously
working system image (SYSnn and ZDLLrrr subvolumes).
If you modified the ZREGPTR file, the ZREG file, or the required public DLL, revert to
the original files and reboot the system.
If you are using unmodified ZREGPTR and ZREG files that DSM/SCM installed, and
the required public DLL is in the public DLL subvolume, contact your service provider
(see Recovery Action Requiring Vendor Support on page 26-6).