NonStop Operating System Event Management Programming Manual

System Monitor Event Messages (ZMON)
HP NonStop Operating System Event Management Programming Manual—520372-020
7-6
Description of ZMON Event Messages
Predefined Token and Field Values
Simple Tokens and Structured Tokens
These tokens are described in the event-message descriptions.
Description of ZMON Event Messages
The system monitor event messages are described in detail on the following pages.
The descriptions are in ascending order by event number. The symbolic name for the
event number is ZMON-EVT-name, where name describes the event that generated
the message.
Topics:

Information in Event Description Messages on page 7-6

Recovery Action Requiring Vendor Support on page 7-7

Descriptions of individual event messages (for a linked list, see Table 7-1 on
page 7-1)
Information in Event Description Messages
Each description contains the following information:

A header showing the numeric value and symbolic name for the event number.

A paragraph describing the event message.

A list:

Identifying the subject of the event message.

Indicating whether the event is channel-related, device-related, or controller-
related.

Indicating whether the message identifies a potentially critical event (whether
ZEMS-TKN-EMPHASIS has the value ZSPI-VAL-TRUE).
Token Description
ZMON-VAL-BUFLEN Recommended buffer length (in bytes) for all system monitor event
messages
ZMON-VAL-SSID System monitor subsystem ID—the structure is shown under the
description for ZSPI-TKN-SSID
ZMON-VAL-VERSION Version number of the system monitor
Note. Each event message also contains the header tokens listed in Section 2, Header and
Common Tokens, and the tokens listed in the Common Definitions on page 3-5.