NonStop Operating System Event Management Programming Manual

System Clock Event Messages (ZCLK)
HP NonStop Operating System Event Management Programming Manual—520372-020
8-9
Messages
Unconditional Tokens
Cause. The operating system set the system time from the RMI clock (on D-series
NonStop operating system RVUs) or from the SP clock (on G-series and H-series
NonStop operating system RVUs) after a system cold load or following a power
outage.
Effect. None.
Recovery. This is an informational message only; no corrective action is needed.
102: ZCLK-EVT-TIMERESET
System time was reset.
Event-Message Text (D-Series)
SYSTEM CLOCK SET FROM RMI CLOCK
Event-Message Text (G-Series)
SYSTEM CLOCK SET FROM SP CLOCK
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZCLK-EVT-
CLOCKSETFROMRMI (101) on D-series NonStop
operating system RVUs and
ZCLK-EVT-CLOCKSETFROMSP (101) on G-series and
H-series NonStop operating system RVUs.
ZCLK-TKN-SYSCLOCK Subject token that specifies that this is a system time event.
Subject: ZCLK-TKN-SYSCLOCK
Potentially critical event: No
Action event: No
Message sender: SETSYSTEMCLOCK procedure
TMDS collector: Yes
OSM/TSM collector: Yes
Unconditional Tokens (pre-D20)
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZCLK-TKN-SYSCLOCK token-type ZSPI-TYP-UINT
ZCLK-TKN-INTERVAL-W-0 token-type ZSPI-TYP-UINT
ZCLK-TKN-INTERVAL-W-1 token-type ZSPI-TYP-UINT
ZCLK-TKN-INTERVAL-W-2 token-type ZSPI-TYP-UINT
ZCLK-TKN-INTERVAL-W-3 token-type ZSPI-TYP-UINT