NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-7
Common Definitions
Topics:

Common Definitions on page 9-7

Description of ZTAP Event Messages on page 9-11
Common Definitions
Common definitions are definitions that are used in several (usually three or more)
event messages for a specific subsystem or system component. Labeled-tape server
($ZSVR) event messages use definitions from the following sources:

Subsystem Programmatic Interface (SPI) Standard Definitions on page 9-8

Event Management Service (EMS) Standard Definitions on page 9-9

Labeled-Tape Server (ZTAP-) Definitions on page 9-10
A general description of these definitions is provided in the following paragraphs.
707: ZTAP-EVT-TPTMWRITEREAD An error occurred during an attempt to
WRITEREAD to TPTM.
708: ZTAP-EVT-TPTMTIMEOUT
A request to TPTM timed out.
709: ZTAP-EVT-TPTMNOTCONFIGURED
A request to TPTM aborted because
TPTM is not configured.
713: ZTAP-EVT-SSIDRIVEBUSY
The ACS drive specified in DEFINE is
currently busy.
992: ZTAP-EVT-SYN-CMD-ABORT
An operation was aborted by a tape
device.
993: ZTAP-EVT-SYN-CMD-ABORT-ON-REQ
An operation was aborted by a tape
device because of an XIO timeout.
1008: ZTAP-EVT-SYN-ERR-INJECTION
The software simulated an error at the
request of the tape device process.
5101: ZTAP-EVT-EXCEPT-ERR
An error or a failing I/O operation was
returned from a module driver.
Note. The event-message header tokens are described in Section 2, Header and Common
Tokens.
Note. All definitions are shown in DDL format using hyphens (-) as separators. If you are
programming in TAL or TACL, substitute the circumflex symbol (^) for the hyphens. If you are
programming in Pascal or C, substitute the underscore symbol (_) for the hyphens. For a quick
explanation of DDL, see the SPI Programming Manual.
Table 9-1. Labeled-Tape Server Event Messages (page 7 of 7)
Event Number and Symbolic Name Description