NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-24
Messages
Unconditional Tokens
Conditional Tokens
Cause. A request was made to use an unlabeled tape on the device indicated by
ZTAP-TKN-DEV-NAME with NL processing mode, but the system is set up to intercept
an NL open and requires operator confirmation to continue.
Effect. The requesting application is suspended until you accept or reject the request.
Recovery. The request is suspended as a outstanding request until one of the
following actions is taken:

Abort the operation with the MEDIACOM REJECT command. $ZSVR generates
the action-completion message ZTAP-EVT-REJECTDEVICE (653).

Accept the operation with the MEDIACOM ACCEPT command. $ZSVR generates
the action-completion message ZTAP-EVT-ACCEPTDEVICE (652).

Leave the request suspended until one of the above actions is taken. If the
processor of the requester goes down while the request is suspended, $ZSVR
generates the action-completion message ZTAP-EVT-CANCELDEVICE (650).
607: ZTAP-EVT-REQBLP
A request was made to use a tape device in bypass label processing (BLP) mode.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
REQNL (606).
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 to 9999.
ZEMS-TKN-TEXT Standard EMS token that contains the message text. See
Event Management Service (EMS) Standard Definitions
on
page 9-9.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.
Token Description
ZEMS-TKN-TEXT Up to 80 bytes of comments that were specified with the
DEFINE attribute MOUNTMSG. These comments provide
information for the operator such as the relative length and
urgency of the job.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: Yes